 |
Peel all labels off a two-liter pop bottle and clean thoroughly. |
|
 |
Have an adult drill two 1/8" holes in the bottom of the
bottle. Thread wire through one hole and out the other. Twist
the ends of the wire together to make a loop for hanging the
feeder. Use a small piece of duct tape or caulk to seal the
holes so rain can't get into the feeder. |
 |
Drill one 5/16" hole, then drill another 5/16" hole
on the opposite side of the bottle. Insert a 5/16" wooden
dowel (approximately 8" in length) through the holes. Repeat
the procedure so that another perch is added 1/2" above
the first (the second perch should cross over the first.) |
 |
Make 1/4" by 1/8" slots 1 1/2" above the perches. |
 |
Remove cap from the bottle and fill feeder with
3-D Pet Products® bird food. Replace cap and hang in a location
where you can enjoy the variety of birds attracted. |
|
